|Sorry, you do not have access to this content.|
NOTE: There are two videos embedded in this post: one for Session 1 and one for Session 2 of the webinar. ONLY Platinum Members can access this post.
A member of my Facebook group asked:
I bought some foam to play with. Could puffy foam be stitched over to bring the snow out?
The answer is a resounding YES! However, it must be done in the Create module of Premier+ 2 (or Premier+)
Amazing new feature:
If the “PLUS” section of the PREMIER+™ 2 website is interpreted correctly in my mind, then this will be mind boggling. Just think about it.
Until now, we had built-in Lettering in the software — hundreds, under the Lettering tab in the Extra module. If we wanted to create additional fonts, we had to digitize them either automagically in QuickFont from fonts already on our computers, or laboriously with a wonderful module called Font Create. The first one works quite well much of the time, while the latter does a terrific job.